Reely RtF 322 mm 1086655 사용자 설명서

 

Before connecting the flight battery to the model, the remote control transmitter must be taken into operati-

on. Observe that the control lever for the motor function is in the bottom position.

Install the flight battery (1) centrally on the hook-and-loop tape on the undercarriage (2) and connect them to the 

model electronics with the plug connector (3) that is protected against polarity reversal.
After approx. 2 seconds, a red LED lights up on the model electronics and signals readiness for operation of the 

model plane. 
The rudder and elevator, as well as the motor react to the movements of the control levers at the transmitter now.

  If the LED is not lit, the transmitter may not be switched on or not recognised by the receiver (see next 

chapter 12).

 

If the LED flashes slowly, the control lever for the motor function was not pushed to the bottom position 

properly.

 

When you want to disconnect the rechargeable battery from the electronics again, hold the model plane with 

one hand by the outer wall in the area of the electronics (4).