ECX Torment ECX03013 데이터 시트

torment

Tapping Binder Head, M3x8mm

Tapping Binder Head, M2.5x4mm

Tapping Binder Head, M3x10mm

Tapping Binder Head, M3x14mm

Tapping Binder Head, M3x16mm

Tapping Binder Head, M3x18mm

Tapping Binder Head, M3x20mm

Tapping Binder Head, M3x22mm

Tapping Binder Head, M3x25mm

Binder Head, M3x10mm

Tapping Flat Head, M2.5x10mm

Tapping Flat Head, M3x10mm

Tapping Flat Head, M3x15mm

Tapping Binder Head, M3x12mm

Washer,

6.2x10.8x0.2mm

Flanged Lock Nut, M4

Washer,

3x8x1mm

Lock Nut M3

Washer,

2.6x6 X0.5mm

Lock Nut M2.5

Setscrew, M3x3mm

Setscrew, M4x3mm

Binder Head, M3x20mm

Binder Head, M3x22mm

Flat Head, M3x8mm

Flat Head, M3x10mm

Flat Head, M4x18mm

Binder Head, M3x12mm

Binder Head, M3x14mm

Binder Head, M3x16mm

Binder Head, M3x18mm

Oil-filled shocks will require regular maintenance due to the oil breaking

down or getting dirty. This maintenance should be performed after about 

every 3 to 5 hours of use, depending on the conditions that the vehicle is

used in.

• Remove the shock from the vehicle.

• Remove the cap from the shock body and dispose of fluid.

• Disassemble the shock. Clean thoroughly with DYN5505. Dry parts

before assembly. 

• Re-assemble the shock and refill the shock body with silicone fluid (30

weight recommended).

• Slowly move the shaft and piston up and down to remove air bubbles.

• Move the piston to the midway point of the body and install the cap.

• Wipe off any overflowing fluid.

• When properly filled, the piston should rebound about 3/8 in (9.5mm)

after being pushed in fully. 

•  Re-install the shock on the vehicle.

Ride height is an adjustment that affects the way the vehicle jumps, 

turns and goes over bumps. Drop one end of the vehicle from approxi-

mately 6 inches (152 mm) in height onto a flat surface. When dropping 

the front of the vehicle, after the vehicle settles, make sure the front 

arms are equal and parallel to the flat surface. Do the same with the rear 

to make sure both arms are parallel with the flat surface. 
Lowering the front ride height increases steering, but decreases 

traction. Lowering the rear ride height increases traction, but decreases 

steering. 

ECX233000

Shock, Complete, (2): 4wd 

ECX233001

Shock Rebuild, (2): 4wd 

ECX233002

Top, Bottom Shock Ends: 4wd

ECX233003

Shock Spring, Black, Set: 4wd

ECX234005

Link Set, Plastic: 1:10 4wd All

ECX236001

Lock Nut, M2.5, (5)

ECX236004

Special Hardware: 1:10 4wd All

ECX233000

ECX233001

ECX233002

ECX234005

ECX236001

ECX236004

ECX233001

ECX233002

ECX234005

ECX233003