Reely 1:10 Electric monster truck model car Audi RS6 4WD P-190 RtR 2.4 GHz QCO1014W000F17SR02 데이터 시트

제품 코드
QCO1014W000F17SR02
다운로드
페이지 120
33
• Keep fuel in well-ventilated rooms only and keep it away from ignition sources.
• Only transport the model when the tank is empty! Empty the tank if you do not want to drive the model for several days.
• Only use appropriate containers for transporting the fuel.
• The fuel can eat away and damage varnish and rubber parts.
• Empty fuel containers as well as any remaining fuel must be disposed of as hazardous waste.
• Do not burn fuel containers!
c) Driving
• Prior to starting:
Check all bolted connections and all wheel nuts.
Make sure that the rechargeable batteries of both transmitter and receiver are completely charged.
Put the pistol grip remote control into neutral. To do so, let go of the lever for the drive function and the steering wheel. Then first turn on the remote control
transmitter and then the receiver.
• Never drive if your ability to respond is limited (e.g. when tired, under medication or under the influence of alcohol). Incorrect responses can cause serious
damage to people and property.
• Do not drive towards groups, persons or animals!
• Always keep visual contact to your model! Do not drive at night.
• Never drive on roads that are open to public road traffic!! Take note of possible conditions and regulations for the site.
• Do not drive in closed rooms!
• Never drive without an oiled air filter!
• Regularly check all screw connections and attachments, as these may come off or loosen due to engine vibrations during driving.
• Avoid slow driving in underload range! The motor and clutch may overheat due to a lack of air cooling during driving!
• Avoid driving at very low outdoor temperatures. The synthetic material of the car body loses its elasticity; thus, even small collisions may lead to splintering and
breaks.
d) Radio Remote Control
• Before starting, check the range of your remote control system.
• Check the charge level indicator of your remote control! Weak or empty rechargeable batteries (or batteries) can cause you to lose control over your model.
• Prior to starting the engine, make sure that the throttle/brake servo is in idle position.
• While the model is not moving, check if the servos respond to the remote commands as expected!
• Secure excess lengths and loose cables with thin cable fasteners! Make especially sure that no lines can be caught in any moving parts.
• Make sure that nobody else nearby is transmitting on your frequency! Interfering signals on the same frequency can make you lose control over your model.
• Do not drive underneath high voltage power lines or radio masts.
• Do not drive in thunderstorms! Atmospheric interferences can affect the signals of your remote control transmitter.
• Don’t drive in the rain, through wet grass, water, mud or snow. The RC system components are not water-proof!
• Always leave the remote control and the receiver turned on whilst the engine is running!
• Switching off: First turn off the engine, then the receiver and finally the transmitter.
e) Batteries and Rechargeable Batteries
• Remove the rechargeable batteries from the receiver if you are not using it for an extended period of time.
• Never mix rechargeable batteries with dry-cell batteries.
• Never mix full and half full rechargeable batteries / batteries or rechargeable batteries with different capacities. Otherwise, the weaker rechargeable batteries
/ batteries or rechargeable batteries with low capacity may be completely discharged and leak
• Never try to charge normal batteries. Danger of explosion!
• Dispose of empty or defective batteries or of batteries that cannot be recharged anymore properly (see chapter on “Disposal”).