Reely Brushless 1:18 RC model car Electric Bugg FS73607 사용자 설명서

If the vehicle does not stop calmly in the neutral position of the throttle/brake lever, you can correct the trimming for 

the driving function at the transmitter.
If the trim path is not sufficient (or if the trim is already almost at the end of the trim path) you can reprogram the neutral

position and the full throttle positions for forward/reverse driving. 
Proceed as follows:
•  Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the trimming for driving into the

centre position.

•  Keep the setup button (2) pressed and turn the speed

controller on („ON“).

•  The  LED  flashes  at  the  speed  controller  then  flashes

red; the motor emits bleeps. Release the setup button 

again.

  If you do not release the setup button, the programming 

mode is activated after a few seconds (see chapter 10. 

b). In this case, switch off the speed controller and pro-

ceed again as described above.

•  Release the throttle/brake at your transmitter so that it

sits in the neutral position.

•  Shortly push the setup button (2). The LED at the speed controller flashes green once and a beep is emitted. The

neutral position is now saved.

  The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, depen-

ding on the motor. In this case, observe the LED on the speed controller.

•  Move the throttle/brake lever at the transmitter to full throttle for forwards driving, pull it towards the handle and hold

it there.

 

If you do not move the transmitter throttle/brake lever during the programming process or do not move it 

far enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become 

uncontrollable. In that case, repeat programming.

•  Shortly push the setup button (2). The LED at the speed controller flashes green twice and two beeps are emitted.

The full throttle position for forward driving is stored.

•  Move the throttle/brake lever to full throttle for reverse driving, push it away from the handle to the stop.
•  Shortly push the setup button (2). The LED at the speed controller flashes green thrice and three beeps are emitted.

The full throttle position for reverse driving is stored.

•  Release the throttle/brake so that it sits in the neutral position.
•  Now wait for at least 3 seconds. The setting mode is left automatically and the speed controller is ready for operation

with the new settings made.

