Reely Brushless 1:10 RC model car Electric Bugg FS53625 사용자 설명서

  The speed controller is already pre-programmed with the most sensible pre-settings ex works.

 

If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether 

undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the 

LiPo battery will suffer deep discharge and be destroyed.

 

If a NiMH driving battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo 

batteries.

The programming can be performed very easily via the setup button.
Proceed as follows for programming:
•  Switch on the transmitter if you haven’t done it already.
•  Switch off the speed controller („OFF“).
•  Keep the setup button (2) next to the on/off switch (1)

pressed and turn the speed controller on („ON“).

  Continue to push and hold the setup button (2). Don‘t 

release it.

•  The  LED  at  the  speed  controller  flashes  red  and  the

motor emits beeps (continue to keep the setup button 

pushed).

•  After some time, the LED flashes green (keep the setup button pushed).
 The number of green flashes (1x .....5x) shows which setting function is currently selected.
 LED flashes green once + 1 beep:  Driving function forward/backward or forward only
 LED flashes green 2x + 2 beeps:  Motor brake
 LED flashes green 3x + 3 beeps:  Undervoltage recognition for LiPo
 LED flashes green 4x + 4 beeps:  Start mode when driving off
 LED flashes green 5x + 5 beeps:  Brake force

  The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, depen-

ding on the motor. In this case, observe the LED on the speed controller.

•  When the desired setting function that you want to change is displayed (e.g. undervoltage protection, LED flashes

3x green + 3 beeps from the motor), release the setup button.

•  Now the LED flashes red again. The number of red flashing signals shows which setting value is active (e.g. under-

voltage protection 3.0 V/cell, red LED flashes 4x briefly red + 4 beeps from the motor).

•  Pushing the setup button briefly changes the setting value. The number of red flashing signals of the LED (and the

motor beeps) changes accordingly.

•  To leave the setting mode and save programming, switch off the speed controller. If you switch on the speed cont-

roller then, the speed controller is ready for operation with the settings made above.

•  If another setting is to be changed, proceed again as described above.

