Carson BRUSHLESS-SET DRAGSTER PRIME 14T 500906164 사용자 설명서

• 

Switch on the transmitter.

• 

Connect the controller to the power supply.

• 

Hold down the SET button and switch the controller on at the on/off switch; 
you will hear a beep.  

 

The blue LED lights up.

• 

Set the throttle/brake lever to the full acceleration position. 

 

The blue LED flashes briefly and then illuminates permanently. 
You will hear a beep.  

 

The full throttle setting is stored.

• 

Move the throttle/brake lever to the full braking position. 

 

The red LED illuminates briefly. Then the red LED and the blue LED illuminate 
permanently. You will hear two beeps. 

 

The brake setting is stored.

• 

Put the throttle/brake lever to neutral. 

 

The blue and red LED lamps flash briefly and then remain illuminated. You will 
hear three beeps.

•   The synchronization is complete, all LEDs are off.

•   Switch the controller off.

When you switch the controller on again, the speed controller is 
synchronized to the transmitter and is fundamentally ready for use.

If your model travels backwards, you need to switch 2 of the 3 motor cables.