Carson BRUSHLESS-SET DRAGSTER PRIME 14T 500906164 사용자 설명서
제품 코드
500906164
43
CARSON DRAGSTER Brushless-Regler
GB
13. Selecting a Pre-programmed driver Profiles
(Throttle/Brake
(Throttle/Brake
Settings)
Profiles 1 - 4 have no influence on the undervoltage protection set at the time
when you selected the type of battery.
when you selected the type of battery.
Driver profile
1
2
3
4
reset to
factory
defaults
5
Cut-Off
as
selected
as
selected
as
selected
as
selected
NiMH
Reverse travel
no
yes
yes
no
yes
Percentage
reverse travel
reverse travel
0
50
50
0
25
Initial braking
performance
performance
30 %
30 %
40 %
40 %
30 %
Parking brake
15 %
10 %
15 %
-
10 %
Dead Band
3
3
4
4
3
•
Press the SET button down until the blue LEDs light up 6 times. Release the
SET button again.
SET button again.
•
The red LED start flashing. This shows that you are in the mode for setting the
driver profile.
driver profile.
•
Press the SET button repeatedly until you reach the required setting. The red
LED flash at the next highest speed.
LED flash at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through the
settings.
settings.
•
When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
seconds; the setting is stored.
•
Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
•
If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
controller reverts to the last setting and is ready for use again.