ECX Brushed 1:10 RC model car Electric Short co ECX03027 사용자 설명서

TORMENT

®

1. Connect the AC power cord to the power slot on the charger, then 

connect the other end of the power cord to an AC power source.

2. The Power LED and Charging LED will turn GREEN when the 

charger is connected to the AC power source.

3. Connect the battery pack connector to the charge connector.
4. Press the On/Off button to charge the battery. The Charging LED 

turns RED.

5. When the battery pack is fully charged, the Charging LED will turn 

GREEN.

6. Press the On/Off button to stop charging. Disconnect the battery 

pack connector from the charge connector.

CAUTION: If at any time during the charge process the 
battery pack(s) becomes hot to the touch, unplug the 

battery immediately and discontinue the charge process.

The vehicle battery charger produces 2000 milliAmps (2 Amps) per 
hour. Divide the mAh capacity on the label of a battery by 2000 to 
know how long battery charging will require. For example, a fully 
discharged 1800mAh battery requires 0.9 hours (54 minutes) to 
charge.

Your Dynamite peak voltage detection charger includes safety circuit-
ry and programming allowing the charger to stop charging after 15 
minutes, if it senses any issues that have come up in charging. The 
high electrical resistance commonly found in new, unconditioned, 
Ni-MH batteries can cause this safety circuit to activate turning the 
charger off before a full charging cycle is complete. This is commonly 
known as a “false peak” in your battery charge.
Should this occur during your fi rst charge cycle, it does not neces-
sarily indicate a failure of either your charger or battery. Instead it 
shows that the charger is functioning properly and that the battery is 
not yet fully conditioned.
To complete your fi rst full charging cycle in the event of a false peak, 
restart the charger by pressing the Start button again. Repeat this 
process until the charge cycle continues to charge past 15 minutes. 

It may take as many as 2 to 4 restarts to complete your fi rst one or 
two full charge cycles. Once your charger completes a charge cycle 
longer than 15 minutes, your battery will be fully charged. A typical 
fi rst full-charge cycle should run for 45 to 90 minutes, depending on 
the self-discharge condition of the battery since it was shipped from 
the factory.
Once your battery is properly conditioned through a few full charge 
and discharge cycles, you will see normal operation of the charger 
by a single press of the start button, followed by a 60 to 90 minute 
charge cycle. 

WARNING: Failure to exercise caution while using this 
product and comply with the following warnings could result 

in product malfunction, electrical issues, excessive heat, FIRE, and 
ultimately injury and property damage.

•  Read all safety precautions and literature prior to use of this 

product.

•  Never leave the battery and charger unattended during use.
•  Never allow children under 14 years of age to charge battery 

packs.

•  Never attempt to charge dead or damaged batteries.
•  Never charge a battery if the cable has been pinched or shorted.
•  Never allow batteries or charger to come into contact with 

moisture at any time.

•  Never charge batteries in extremely hot or cold places 

(recommended between 50–80°F (10–26°C)) or place in direct 
sunlight.

•  Always use only Ni-MH rechargeable batteries. This charger 

cannot charge batteries such as “heavy duty”, “alkaline”, 
“mercury” or “lithium” battery.

•  Always connect to the charger correctly.
•  Always disconnect the battery and charger after charging and let 

them cool between charges.

•  Always inspect the battery before charging.
•  Always terminate all processes and contact Horizon Hobby if the 

product malfunctions.

•  Always make sure you know the specifications of the battery to 

be charged or discharged to ensure it meets the requirements of 
this charger.

•  Always constantly monitor the temperature of the battery pack 

while charging.

•  Always end the charging process if the charger or battery 

becomes hot to the touch or starts to change form during the 
charge process.

•  Always charge in a well ventilated area.

1. ECX

®

 Torment

™

 1/10-scale Short Course Truck 

2. Spektrum

™

 DX2E Transmitter

3. AA (4) Batteries
4. DYN4113 2A Peak Battery Charger 
5. Dynamite

®

 Speedpack™ 7.2V 

Ni-MH battery (DYN1050EC)