Carson Electric dual-rotor helicopter RtF (500507041) 500507041 데이터 시트

The Carson 2.4 GHz system finds a free transmitting frequency 
automatically, so does not need to be equipped with the transmitter 
and receiver crystal that are 
normally required.

The built-in components are already coordinated. These must not be 
re-synchronised.

To synchronise the transmitter with other receivers, please following 
the following procedure: 

1.  Put batteries/accumulators into the 2.4 GHz transmitter and switch 

it off.

2.  Press the bind button that is linked to the receiver via a cable.

3.  Connect the battery lead to the receiver (Illustration 1). 

 

The 2 LEDs begin to flash and confirm the “match” status for 
synchronising the transmitter and receiver. 

4.  Press and hold down the synchronisation button on the 

transmitter, then switch the ON/OFF switch on the transmitter to 
ON (Illustration 2). 

5.  Release the bind button on the transmitter and receiver again.

6.  Check the LEDs on the receiver. If the LEDs are no longer flashing, 

the synchronisation process has been successfully completed. 
However please wait for a further 10 seconds. 

7.  Connect the servo plug to the receiver and check that it works 

(Illustration 3). 

8.  If the test is not successful, please repeat the procedure starting at 

point 1. 

9.  If the test is successful the accumulator pack may be reconnected 

to the accumulator plug. 

The synchronisation of the transmitter and receiver is now complete.