Carson Electric dual-rotor helicopter RtF (500507041) 500507041 데이터 시트

1.  Open the battery compartment lid.

2.  Insert the battery into the battery compartment.

3.  Leave the connecting lead hanging out and then replace the lid on 

the battery compartment.

•  Connect the Lipo Balance charger to the power supply’s cable. 

•  Connect the LiPo battery’s white balance connector to the LiPo 

Balance charger.

•  The battery is completely charged when all 3 leds flash up green.

The helicopter must be correctly balanced. If there is an incorrect 
location of the centre of gravity, you lose the control over the model!

The location of the centre of gravity of the model is preset. 
Corrections are only necessary if you are not satisfied with the flight 
characteristics. 

The centre of gravity of the helicopter-model should lie exactly in the 
rotation point of the rotor axis.

Shift the airplane battery in order to determine the optimal location 
of the centre of gravity.

•   Hang the helicopter on the upper rotor head, in the extension 

of the axis of rotation. The helicopter may not tip forwards or 
backwards, no matter in which position the principal rotor blades 
are located.

•  If the nose drops, then the model is top-heavy. Shift the airplane 

battery slightly backwards.

•  If the tail sinks, shift the airplane battery forward in order to adjust 

the centre of gravity.

Secure the airplane battery when you have determined the optimal 
location of the centre of gravity.

Support the helicopter at the end of the tail beam and front on the 
longitudinal axis as far as possible. To do this, remove the cabin hood. 
The helicopter may not tip to one side, no matter in which position 
the principal rotor blades are located.