Uhlenbrock 81310 Digital-Servo 81310 데이터 시트

1 

 
 

 

•  For Märklin oder DCC Digital systems and Analogue operation 
•  Integrated Digital decoder 
•  Switchable by locomotive functions, solenoid or proportional to speed setting  
• Configurable turning speed 
•  Up to four configurable stop positions 
•  Rotation angle up to 180° 
•  Configured by DCC CV programming or by a Motorola Digital center 
•  With mounting material, cam levers and control wires 

2 x 0.4 mm and 1 x 0.6 mm, length 100 mm 

•  Torque 2 Ncm 
•  Dimensions 20.0 x 17.6 x 8.0 mm

 

The digital servo with the integrated digital decoder is suitable for installation in vehicles, as well as for use 
in stationary working models.  The quiet, smooth running spoils even the fastidious Model railroader.  The 
servo moves the item with the enclosed control wire. In vehicles for example

,

 pantographs or doors can be 

moved. In fixed items for example, it can move turnouts, signal semaphores, boom gates, water cranes and 
gates. 

With the enclosed mounting material the servo can be installed in many different positions. 

The digital servo has two connecting wires which are connected in an analogue operation as shown below 
or in digital operation to the track power from the digital center or a Booster.  

Meaning for the connection: 
Plus to red, Minus to black wire – the Servo moves to Position 1. 
Plus to black, Minus to red wire – the Servo moves to Position 2. 

 

The servo operates for as long 
as a key is pressed, up to the 
stop position.  

 

Analogue Operation 

The Servo can be operated with DC or AC voltage between 
10V und 20V.

 

Depending on the polarity the servo moves 

between two programmable end positions at a maximum 
angle of 180°.  These end positions can be programmed, for 
use in an analogue system, with a digital center in CV261 
for position 1 and CV262 for position 2 (see the section 
“Programming “). 

Bit 0 in CV 29 can be used to swap the rotation direction.