Renkforce MP 2000 MP-2000 데이터 시트
제품 코드
MP-2000
22
7. Installation/Setup
When selecting the set-up or installation site, observe that direct sunlight, vibration, dust,
heat, cold and moisture must be avoided. There also must not be any strong transformers in the
proximity.
proximity.
Ensure sufficient ventilation when setting up the device with other equipment. Keep a suffici-
ent distance from heat sources. Never put up the device in direct proximity of heat sources. Do
not point any strong spotlights or light sources towards the device. This may cause overhea-
ting (danger of fire!).
not point any strong spotlights or light sources towards the device. This may cause overhea-
ting (danger of fire!).
Heat removal from the device must not be obstructed. Never place it on any soft surfaces such
as a carpet or a bed. Never cover the device’s ventilation openings. Air circulation must not be
obstructed by objects such as magazines, tablecloths, curtains or similar. This prevents heat
dissipation and may lead to overheating (danger of fire!).
obstructed by objects such as magazines, tablecloths, curtains or similar. This prevents heat
dissipation and may lead to overheating (danger of fire!).
Always remove both rack covers in operation if the amplifier is rack-mounted!
Only operate the amplifier on a stable underground that is not sensitive to heat, and in a hori-
zontal position; otherwise, air circulate is not warranted correctly.
Ensure secure attachment or stable set-up. The device is heavy and therefore poses consi-
derable danger of accidents.
Do not drill or screw any additional screws into the casing for mounting. This may expose
dangerous voltage to touch.
Make sure that the connection cables are not squeezed or damaged by sharp edges. Always
place cables so that no one can trip over them or be caught in them. Danger of injury!
The cables must be sufficiently long. Do not put any mechanic strain on them. This may damage
the cables or device. There is a risk of dangerous electric shock.
Due to the diversity of furniture paints and polishes used, it is possible that the device’s feet will
leave visible residue on furniture due to chemical reaction. The device therefore should not be
placed on valuable furniture surfaces without any suitable protection.
The amplifier can be set up on a level surface or installed in a 48.3 cm (19“) rack.
Use in a rack
• The amplifier’s front plate has four attachment holes. Attach the device in the rack with four sufficiently
• The amplifier’s front plate has four attachment holes. Attach the device in the rack with four sufficiently
large screws.
• Attachment at the front plate alone, however, is not sufficient for secure attachment. Additionally, even
attachment must be provided for by side and bottom rails. The respective rack producers offer different
options for this.