3D Systems 350166 데이터 시트

MATERIAL CARTRIDGE INSTALLATION

1. Remove material cartridge from packaing; using scissors cut top portion of bag and remove the cartridge.
2.

Tap “Setup” on Cube touch screen then select “Load Cartridge,” press Next.

Do not pull material until thumbscrew is removed from cartridge. Doing so will damage cartridge.

3. Remove thumbscrew on the side of the material cartridge. Remove the blue tape from material. Retain

screw to re-install in cartridge when you need to store cartridge again. Press Next to begin the cartridge

installation.

Remove and

retain screw.