3D Systems 350166 데이터 시트
45
2. On the Cube touchscreen, finger tap check box to start the build file or tap the
X box to cancel.
3. The Cube will begin a ten minute heating process. During the heating process, the print tip and the print pad will reach the
temperatures that have been preset by the manufacturer. Once these temperatures are reached, your creation will begin to
print.
Tap here
WARNING –
PRINTJET NOZZLE TIP BECOMES EXTREMELY HOT DURING SET-UP AND OPERATION. DO
NOT TOUCH NOZZLE.
Do not change cartridge material during printing; doing so may damage the Cube.
NOTE: During printing operation, please do not place a cover over your Cube. The Cube generates heat during
printing and if covered, it can cause damage to the Cube.
Printing From the USB Memory Stick
1. If you are using your USB memory stick to download your Cube file, please install the USB memory stick into the USB port on
1. If you are using your USB memory stick to download your Cube file, please install the USB memory stick into the USB port on
your computer. Open the file folder where your Cube file is located and save it on the USB memory stick. Remove memory
stick and install it into the Cube’s USB port.