3D Systems 350166 데이터 시트

58

•

If the pad needs to be moved up, turn the front adjusting knob bolt clockwise to loosen and then turn the back adjusting 

knob bolt clockwise. To move the pad down, turn the  back adjusting knob bolt counterclockwise.

•

While adjusting, slide the paper between the print jet tip and print pad where the adjustment was needed; the paper 

should slide back and forth with no resistance. If resistance is felt, the pad is too high. Please repeat the adjustment. 

•

Once adjustments are made, tighten the adjusting knob bolts.

 

If the gap between the print pad and print jet tip is at the front or back of pad, adjust the pad using the adjusting knob bolt.

 

If the gap between the print jet tip and the print pad is too 

low, the pad is too low and will need to be moved up.