TP-LINK JetStream TL-SG3216 TL-SG3216 데이터 시트
제품 코드
TL-SG3216
storm-control unicast
Description
The
storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use
no storm-control
unicast command. Unicast control function allows the switch to filter UL frame in
the network. If the transmission rate of the UL frames exceeds the set bandwidth,
the packets will be automatically discarded to avoid network broadcast storm.
the network. If the transmission rate of the UL frames exceeds the set bandwidth,
the packets will be automatically discarded to avoid network broadcast storm.
Syntax
storm-control unicast [ rate rate ]
no storm-control unicast
no storm-control unicast
Parameter
rate —— Select the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. The value of it can be 128k |
256k | 512k | 1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default, the
value is “128K”.
traffic exceeding the bandwidth will be discarded. The value of it can be 128k |
256k | 512k | 1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default, the
value is “128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
gigabitEthernet)
Example
Enable the unicast control function for port 5:
TL-SG3424(config)# interface gigabitEthernet 1/0/5
TL-SG3424(config-if)# storm-control unicast
bandwidth
Description
The
bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use
no bandwidth
command.
Syntax
bandwidth {[ ingress ingress-rate ] [ egress egress-rate ]}
no bandwidth { all | ingress | egress }
no bandwidth { all | ingress | egress }
138