TP-LINK JetStream TL-SG3424 TL-SG3424 데이터 시트
제품 코드
TL-SG3424
+ Port Mirroring enables monitoring selected ingress/egress traffic.
+ Simple Network and Management Protocol (SNMP) can be configured over IPv6 transport.
+ IPv6 supports stateless autoconfiguration to manage link, subnet, and site addressing
changes.
changes.
+ DHCPv6 enables switch to receive configuration parameters, such as IPv6 network
addresses from DHCPv6 servers.
addresses from DHCPv6 servers.
2.3 Appearance Description
2.3.1 Front Panel
Figure 2-1 Front Panel
The following parts are located on the front panel of the switch:
10/100/1000Mbps Ports: Designed to connect to the device with a bandwidth of 10Mbps,
100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED.
SFP Ports: Designed to install the SFP module. TL-SG3424 switch features some SFP
transceiver slots that are shared with the associated RJ45 ports. The associated two ports are
referred to as “Combo” ports, which means they cannot be used simultaneously, otherwise only
SFP ports work.
Note:
When using the SFP port with a 100M module or a gigabit module, you need to configure its
corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M
module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed
and Duplex mode of SFP port is 1000MFD.
corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M
module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed
and Duplex mode of SFP port is 1000MFD.
Console Port: Designed to connect with the serial port of a computer or terminal for monitoring
and configuring the switch.
LEDs
Name
Status
Indication
On
Power is on.
Flashing
Power supply is abnormal.
Power
Off
Power is off or power supply is abnormal.
On
The switch is working abnormally.
Flashing
The switch is working normally.
System
Off
The switch is working abnormally.
1000Mbps
On
A 1000Mbps device is connected to the corresponding
port.
port.
7