Funai WD6D-M100 WD6DM100 데이터 시트

20

EN

When you turn on this unit for the first time, you need to follow 
these steps.

Q].

“Initial Setting” will automatically appear.

Select your desired language for the OSD using 
[K

\ L]. Then press [ENTER\OK] to go to the 

Select your desired country for receiving your 
local channels properly using [K

\ L]. Then 

\OK] to go to the next step.

This setting is mainly for digital channels.

Digital channels cannot be received properly for the 
countries not listed above.
In such case, select “Other”.

Select your desired tuning type according to 
your area using [K

\ L], then press 

\OK].

The unit will start getting channels available in your area.

Digital tuning:
Only the DVB channels receivable in your area are 
automatically scanned and memorised.
Digital & Analog tuning:
Both analogue and DVB channels receivable in your area 
are scanned and memorised automatically. 
Analog tuning:
Only the analogue channels receivable in your area are 
automatically scanned and memorised.

• If no channel has been memorised, the antenna 

confirmation display will appear. Press [ENTER

\OK] to start 

auto scanning again or press [RETURN

\BACK] to cancel 

the initial settings.

• The current date and time will appear automatically.
• If the current date and time are correct, press 

\BACK] to exit, if they are incorrect, press 

\OK] and follow to “A Clock Setting” on 

page 67. 

• After “Initial Setting”, if you need to unplug the mains cable, 

make sure to turn off the power first and leave it in standby 
mode for at least 1 minute before attempting to unplug. 
Otherwise, it may cause data loss.

If you want to set each item of “Initial Setting” again, you can 
set them at “General Setting”.
• Refer to “

A OSD Language (Default: English)” on page 66.

• Refer to “Country Setting” on page 23.
• Refer to “Auto Tuning (DVB & ANALOG)” on page 21.
• Refer to “Auto Tuning (ANALOG)” on page 21.
• Refer to “Auto Tuning (DVB)” on pages 22-23.
• Refer to “Clock” on page 67.

Also you can customize the memorised channel at “General 
Setting”.
Refer to following pages for details.
• Refer to “Manual Tuning (ANALOG)” on pages 21-22.
• Refer to “Manual Tuning (DVB)” on page 23.
• Refer to “Skip a Preset Channel” on page 22.
• Refer to “Move” on page 22.

Use this feature to adjust the aspect ratio of the video source 
which is different from your TV’s ratio to fit your TV monitor 
without distorting the picture.

In stop mode, press [SETUP]. Select “General 
Setting” using [K

\ L], then press [ENTER\OK].

Select “Video” using [K

\ L], then press 

\OK].

Select “TV Aspect” using [K

\ L], then press 

\OK].

Select the desired option using [K

\ L], then 

\OK].

Basic Setup / TV View Operation

E9TF0ED_EN.book  Page 20  Wednesday, March 17, 2010  1:32 PM