Renkforce Weatherproof socket strip 4 x Stone grey 1168609 1168609 데이터 시트

제품 코드
1168609
다운로드
페이지 3
  Operating instructions
  4-socket garden power outlet grey
 
Item no. 1168609
Intended use 
The product features 4 sockets and is intended for connecting electrical loads such as pond 
ventilations, fountains, garden lights, etc. The total power consumption of all connected 
loads must not exceed 3680 W.
The product is splash proof and suitable for outdoor use (IP44).
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If 
you use the product for purposes other than those described above, the product may be 
damaged. In addition, improper use can cause hazards such as short circuiting, fire, electric
shock etc. Read the instructions carefully and keep them. Make this product available to 
third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company 
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
•  Garden power outlet
•  Operating instructions
Safety instructions                       
Read the operating instructions carefully and especially observe the safety 
information. If you do not follow the safety instructions and information on proper 
handling in this manual, we assume no liability for any resulting personal injury 
or damage to property. Such cases will invalidate the warranty/guarantee.
•  Only use a properly installed mains outlet of the public power supply as a 
power source.
•  The mains outlet must be located near to the device and be easily accessible.
•  Never pull the mains plug from the socket by pulling at the cable. Always pull it 
from the mains socket using the intended grips.
•  Unplug the mains plug from the mains socket if you do not use the device for 
an extended period of time.
•  For safety reasons, always unplug the device in case of a thunderstorm.
•  Make sure that the mains cable is not squeezed, bent, damaged by sharp edges 
or put under mechanical stress. Avoid excessive thermal stress on the mains 
cable from extreme heat or cold. Do not modify the mains cable. Otherwise the 
mains cable may be damaged. A damaged mains cable can cause a deadly 
electric shock.
•  Do not touch the mains cable if it is damaged. First, power down the respective 
mains socket (e.g. via the respective circuit breaker) and then carefully pull the 
mains plug from the mains socket. Never use the product if the mains cable is 
damaged.
•  To prevent risks, damaged power cables may only be replaced by the 
manufacturer, a professional workshop appointed by the manufacturer, or a 
similarly qualified person.
•  Never plug in or unplug the mains plug when your hands are wet.
•  Do not overload the product. Heed the power rating in the chapter “Technical 
data”.
•  Do not connect the product in series! This could result in overloading the 
product.  This  poses  a  fire  hazard!  Connect  the  power  plug  of  the  product
directly to a wall socket. Do not connect any additional garden power outlets 
or other convenience receptacles to the product.
•  Do not operate the product when covered! In case of higher installed loads the 
garden power outlet and the connecting cable warm up, which could cause 
overheating or even fire if the product is covered.
•  The product must be unplugged in order to fully disconnect it from the mains.
•  Never point a garden hose at the product.
•  The device is not a toy. Keep it out of the reach of children and pets.
•  Do not leave packaging material lying around carelessly. These may become 
dangerous playing material for children.
•  Protect the product from extreme temperatures, direct sunlight, strong jolts, 
high humidity, moisture, flammable gases, vapours and solvents.
•  Do not place the product under any mechanical stress.
•  If it is no longer possible to operate the product safely, take it out of operation 
and protect it from any accidental use. Safe operation can no longer be 
guaranteed if the product:
 - is visibly damaged, 
 - is no longer working properly, 
 - has been stored for extended periods in poor ambient conditions or 
 - has been subjected to any serious transport-related stresses.
•  Please handle the product carefully. Jolts, impacts or a fall even from a low 
height can damage the product.
•  Also observe the safety and operating instructions of any other devices which 
are connected to the product.
•  Consult an expert when in doubt about operation, safety or connection of the 
device.
•  Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
•  If you have questions which remain unanswered by these operating instructions, 
contact our technical support service or other technical personnel.
Installation location
•  Never install the product in a depression or hollow as puddles could form in these places.
•  Instead, install the product on a firm, horizontal and even surface from which rainwater
can run off without entering the housing of the product.
Operation
•  Connect the power plug to an appropriate power outlet.
•  Connect your switched off devices to the power sockets. Guide the cables through the
intended recessions. Make sure the cables do not get jammed when closing the cover 
of the housing.
•  Turn on the connected devices.
Maintenance and cleaning
•  This product does not require maintenance. There are no components located inside the 
product you need to maintain. Never open/dismantle the product. Have maintenance and 
repairs done by qualified experts or repair shops only.
•  Never use any aggressive cleaning agents or chemical solutions as they may cause 
damage to the housing or the product to malfunction.
•  Never point any water jet, such as that of a high-pressure cleaner, at the product.
•  Before each cleaning, disconnect the power plug of the product from the power outlet 
and disconnect all connected loads from the product.
•  Clean the housing with a slightly damp cloth. Use a few drops of a mild detergent in case 
of heavy staining.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the 
household waste.
At the end of its service life, dispose of the product according to the relevant 
statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Nominal voltage ......................................250 V/AC, 50 Hz
Connected load/current .........................max. 3680 W / 16 A
Protection type ........................................IP44
Cable type.................................................H07RN-F 3G 1.5 mm²
Operating conditions ..............................-25 to +40 ºC, <95 % RH
Storage conditions..................................-25 to +40 ºC, <95 % RH
Cable length .............................................5 m
Dimensions (W x H x D)..........................200 x 215 x 200 mm
Weight .......................................................4 kg
These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). 
All  rights  including  translation  reserved.  Reproduction  by  any  method,  e.g.  photocopy,  microfilming,  or  the  capture  in  electronic  data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. 
These operating instructions represent the technical status at the time of printing. 
© Copyright 2014 by Conrad Electronic SE. 
V1_0514_02-ETS-Mkd