ABUS Pen with integrated surveillance camera BS Pen 4 HR Resolution 1280 x 960 Pixel BS Pen 4 HR 데이터 시트

B & S Technology GmbH – www.bus-sitech.de 

 

 

 

Any information given base on manufacturer specifications. Printing errors, technical changes and errors are possible. They are subject to change 
without further notice. Powered by: B&S Technology GmbH, Germany  -www.bus-sitech.de -  

 

…as a pen: 
Please turn the silver pen tip to use this device as a ballpoint pen. Attention: this 
feature is only for camouflage. Thus, we don`t provide any warranty on this feature. 

 

To take a video, please switch the small black button at the USB-slot to the left 

1.   turn on the device by pressing the control button (6) for around 3 seconds,  as soon as the device is 

ready, the LED will light blue. 

2.  To start the record, please press the control button again, so the LED will light yellow. 

3. To end the stop the record, please press the control button once again so the LED will light blue 
again. 
4. To turn off the device, please press the control button for around 3 seconds 

 

To take a video, please switch the small black button at the USB-slot to the right and proceed according 
to what is explained at “take videos” 

Please connect to device to the USB-cable first, then press the control button (6) until the LED lights, 
then connect the other end of the USB-cable to your computer (while still pressing the button). Release 
the button of the connection between the device and the PC is done properly, so your computer will 
recognized the device as a webcam automatically. If you have questions about how to use a webcam at 
your computer, please refer to the computer`s manual. 

 

Software to watch the videos can be downloaded f.e. from http://www.videolan.org. 
 

1. Turn off the device 
2. Connect the device to the power adaptor 
3. During charging, the status LED (4) lights 
4. A full charge takes about 4 hours to be completed. Please don`t leave the device unattended during 
charging, as heat from the battery or the power adaptor may cause fire in case over overvoltage. Please  
put the device on an fireproof surface and always keep it out of the reach of children. 

 

This device will display date and time (YYY-MM-DD HH:MM-SS) in any video or photo. To set date and time, 
please  

 

- 

Create a txt-file (Editor-file) with your PC (right Click on your desktop) 
In the first line, please insert f.e.  

if your present date is December 24th, 2020 and it is 7 o`clock pm (time will be displayed in 24h-mode) 

- 

Save it, but change the name to time.txt (your computer should use the “.txt” suffix automatically) 

- 

Connect the device to your computer 

- 

Copy the file you just have created into the main folder of the watch (next to, but NOT INTO „DCIM"-
folder) 

- 

Disconnect the watch from USB-cable, turn it off, then on again (to ensure the device is rebooting so 
your settings are finished (If you connect it to your computer again, the „time.txt” file should not be 
displayed any longer) 

 

- 

Note: At any time you initiate a reset or battery is too low, you have to do this settings again