Carson RC console 2.4 GHz No. of channels: 6 501001 데이터 시트

Many publications say that the setup sequence 
for the transmitter and receiver don’t play a 
role anymore with 2.4 GHz sets. However, we 
recommend sticking to the sequence typical for 
previous sets.

•   Before operation: First turn on the transmitter, 

then the receiver. Lastly, connect the drive 
battery to the control unit.

•   After operation: Disconnect the battery from the 

control unit. Turn the receiver off, and then the 
transmitter.

•   Before and after operating the transmitter, make 

sure that trim is in the desired place and that all 
checks have been made.

Battery eliminator is installed in the receiver 
circuitry. The receiver gets supplied with current 
through the drive battery that runs the engine. 
NiMH battery from 6 V to 8.4 V can be used for

the receiver. Batteries of higher voltage may 
damage the receiver and servos.
Use only a speed controller which has the exclusive 
connector for the BEC system.

MADE IN CHINA

Make sure that male and female connectors 
have the correct polarity!