Carson RC console 2.4 GHz No. of channels: 6 501001 데이터 시트

In addition to control information, when the remote 
control is operating, an electronic identifier is 
sent with each transmitter impulse. This is how 
the receiver recognizes that the signal has come 
from its own transmitter. Since many millions of 
transmitter identifiers are available, it is extremely 
unlikely that a different transmitter could influence 
your receiver. 

Upon first use, however, the transmitter must 
communicate this identifier to teach each new 
receiver. For this purpose, the following process 
is necessary. To the degree possible, it should be 
undertaken at a place where no other electrical 
signal – especially not one from another 2.4 GHz 
transmitter – can interrupt this transmission over 
the radio path. 

1.   Place the transmitter and model next to each 

other at a short distance. They should be 
operational but shut off. 

2.   Hold down the setup button on the transmitter 

and turn on the transmitter. An acoustic signal 
sounds. Now, at low power, the transmitter gives 
off signals and its blue LED display blinks slowly.

3.   Hold down the setup button on the receiver and 

turn on the receiver. The red LED on the receiver 
will light up temporarily. Let up on the button 
a short time later. In this mode, the receiver 
registers the transmitter’s identifier and stores it. 
From that moment on, the receiver accepts only 
(radio) control signals that are accompanied by 
that transmitter’s identifier.

4.   The next time the receiver is switched on, its 

continuously glowing LED shows that it is ready 
to run.

1.  Servo reverse steering

2.  Servo reverse throttle

3.  Servo reverse special function left control lever

4.  Servo reverse special function right control lever