Reely Hendheld RC 2.4 GHz No. of channels: 2 1302221 사용자 설명서

When you move the operating lever for the drive function (see figure 1, item 3) towards the handle to the stop, the

model must accelerate (see figure 13, sketches A). If you press the lever forwards, the model must decelerate or

switch to reverse driving (see figure 13, sketches B).

If your model‘s drive reacts opposite to the indication in figure 13, use the drive function reverse switch (see figure 12,

item 7) to switch the effective direction of the operating lever.

 

In a model with a combustion engine, set the linkage for carburettor and brake linkage so that the throttle/

brake servo is not limited mechanically. The trim setting for the driving function must be in the middle positi-

on.

For a model with an electronic speed controller, the different positions of the operating lever fort he drive

function (forwards, stop, reverse) may have to be programmed into the speed controller. Further information

on this can be found in the documents for the speed controller. If the speed controller is not programmable, 

adjust the trim so that the vehicle will stand when the operating lever for the driving function is not in the

middle position.

When you have verified or set the correct driving and steering function, first switch off the receiver and then the

transmitter.
Your model is now ready for its first test run.