Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

AIL 3

(Chip Aileron)

AIL 4

(Chip Aileron)

AIL1

(Main Aileron)

AIL 2

(Main Aileron)

FLP 2

(Camber Flap)

FLP 1

(Camber Flap)

[Corresponding model type]: Airplane/glider, 2 ailerons + 2 flaps or 

more

This mix operates the camber flaps (FLP1/2) 

in the aileron mode. When the aileron stick 

is manipulated, the ailerons and camber flaps 

perform aileron operation simultaneously to 

significantly improve the roll axis.

● The aileron left/right mixing rate of each flap servo 

can be independently adjusted.

● An ON/OFF switch can be set.

● Linking is possible: Link this mix to other mixes.

● Adjustment of each 

flap servo

  Move the cursor to the [ACT] item and touch 

the RTN button to switch to the data input 

mode. Select the ACT mode by scrolling the 

touch sensor. 

*The display blinks.

  Touch the RTN button to activate the 

function and return to the cursor mode. (ON 

is displayed.)

  When selecting a switch, move the cursor to 

the [SW] item and touch the RTN button to 

call the selection screen. Select the switch 

and set its ON direction. (Always ON at "--" 

setting)

*For a description of the switch selection method, see the 

description at the back of this manual.

  Move the cursor to the flap (FLP) 1~2 left 

or right item according to the wing type 

and touch the RTN button to switch to the 

data  input  mode.  Adjust  the  mixing  rate 

independently by scrolling the touch sensor. 

  Initial value: 0%
  Adjustment range: -120~+120%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to end the adjustment 

and return to the cursor mode.

  When linking a mix, move the cursor to the 

[LINK]  item  and  touch  the  RTN  button  to 

switch to the data input mode. Select the 

ON mode by scrolling the touch sensor. 

*The display blinks.

  Touch the RTN button to set the link mode 

and return to the cursor mode.

● Select [AIL to CMBFLP] at the Model 

menu and access the setup screen 

shown below by touching the RTN 

button.

*The display screen is an example. The actual 

screen depends on the model type.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Glider: Currently selected condition name)