TP-LINK 16-Port Gigabit Desktop/Rackmount Switch TL-SG1016D 사용자 설명서

 

II 

 

This equipment has been tested and found to comply with the limits for a Class A 
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference when the equipment is 
operated in a commercial environment. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance with the 
instruction manual, may cause harmful interference to radio communications. 
Operation of this equipment in a residential area is likely to cause harmful interference 
in which case the user will be required to correct the interference at his own expense. 

This device complies with part 15 of the FCC Rules. Operation is subject to the 
following two conditions: 

1)  This device may not cause harmful interference. 
2)  This device must accept any interference received, including interference that may 

cause undesired operation. 

Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment. 

This is a class A product. In a domestic environment, this product may cause radio 
interference, in which case the user may be required to take adequate measures. 

 

  Note:   

As for TL-SG1008, a fuse resistor is used in the “F1” position on the PCB of the power 
module. The fuse resistor should be used with the following type: 10ohm 2W@25

℃.