Canon DR-F120 9017B003 데이터 시트
제품 코드
9017B003
61
Chapter 9 Regular Maintenance
Clean the scanner and perform maintenance on a regular basis as
described below to maintain peak scanning quality.
described below to maintain peak scanning quality.
When cleaning the scanner and inside of the feeder, be sure to
turn off the power and disconnect the power plug from the outlet
beforehand.
beforehand.
Do not use spray cleaners to clean the scanner. Precision
mechanisms, such as the light source, may get wet, and cause
a malfunction.
a malfunction.
Never use paint thinner, alcohol, or other organic solvents to
clean the scanner. Such solvents can damage or discolor the
exterior of the scanner, or create a risk of fire or electrical shock.
exterior of the scanner, or create a risk of fire or electrical shock.
Routine Cleaning
Clean the scanner on a regular basis to maintain scanning perfor-
mance.
mance.
For safety, always turn the power switch OFF and disconnect
the power cord before cleaning the scanner and the inside of
the feeder.
the power cord before cleaning the scanner and the inside of
the feeder.
Do not use spray-type cleaners to clean the scanner. Precision
mechanisms may get wet and malfunction.
mechanisms may get wet and malfunction.
Never use paint thinner, alcohol, or other solvents to clean the
scanner. Doing so may deform, discolor, or dissolve surfaces,
or result in a fire or electric shock.
scanner. Doing so may deform, discolor, or dissolve surfaces,
or result in a fire or electric shock.
Cleaning the Scanner
Use a cloth dampened with water and thoroughly wrung out to clean
the outside of the scanner, and use a clean dry cloth to wipe the
scanner dry.
the outside of the scanner, and use a clean dry cloth to wipe the
scanner dry.
Cleaning the Scanning Glass and Pressure Board
If your scanned images contain lines or smudges, or if the scanned
documents are dirty, then the scanning glass or the Pressure Board
inside the scanner may be dirty. Clean them periodically.
documents are dirty, then the scanning glass or the Pressure Board
inside the scanner may be dirty. Clean them periodically.