Canon DR-F120 9017B003 데이터 시트

image and other documents becoming dirty. Always make sure 
that the ink on a document is dry before scanning it.

 Scanning documents that are written in pencil or similar material 

will make the rollers and scanning glass dirty, resulting in 
smears on the scanned image.

 When scanning thin paper, text or images on the reverse side of 

the page may bleed through onto the scanned image. In this 
case, adjust the brightness under the scanning conditions.

 Always make sure to check that paper clips, staples, and similar 

objects are not mixed in with a document before loading it into 
the feeder. The presence of such objects may result in damage 
to documents, paper jams, and damage to the scanner.

 Do not wear loose clothing or jewelry that may get caught in the 

scanner while you are using it. Doing so may result in personal 
injury. Be extra careful of neckties and long hair. If anything 
becomes caught in the scanner, immediately disconnect the 
power plug from the power outlet to stop the scanner.

 Documents with curled edges may result in folds and paper 

jams. Make sure to straighten out the curls before loading docu-
ments in the scanner.

 Handle paper edges with care, and be careful not to cut your fin-

gers when loading documents.

Document Scanner, Model M111221

This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: (1) This device may not 
cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause 
undesired operation.

Note: This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This 
equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the 
equipment OFF and ON, the user is encouraged to try to correct the 
interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for 

help.

 Use of shielded cable is required to comply with Class B limits in 

Subpart B of Part 15 of FCC Rules.

Do not make any changes or modifications to the equipment unless 
otherwise specified in the manual. If such changes or modifications 
should be made, you could be required to stop operation of the 
equipment.

Canon U.S.A. Inc.

ONE CANON PARK, MELVILLE, NY 11747, U.S.A.

Tel. No. (800)652-2666