Bushnell Solar Wrap Mini PP1011BG 사용자 설명서

Solar panel surface 
facing the sun

will allow you to monitor the charging process.  
If you did not pre-charge the SolarWrap Mini’s battery: detach the end of 
the solar panel roll from the cylinder (fabric under the end of the roll helps 
hold it in place) and unroll it out to its full length. Place the SolarWrap in 
a location where the solar panel surface will be exposed to as much direct 
sunlight as possible 

(D). The hole at the tab end of the solar panel roll can 

be used to stake it to the ground to keep it  securely in place on a windy 
day, or hang it from a tree or your backpack with a carabiner. The LED near 
the INPUT port on the side of the SolarWrap Mini’s cylinder will change 
from red to green to indicate a full charge. Allow up to 10 hours to charge 
the internal battery from a fully discharged condition. Once the battery has 
been charged, connect and charge your device at anytime, as described 
above in “If you pre-charged the SolarWrap Mini battery...” . 

4.  The SolarWrap Mini’s solar panel can be rolled back up to help keep it protected 

from accidental damage once you are charging your device from the internal 
battery, and should always be rolled up when you are storing the SolarWrap 
Mini away for travel. Be sure to roll it back onto the cylinder with the solar panel 
side facing outwards 

(E), not inwards toward the cylinder (black lining facing 

out). Replace the end caps when storing the SolarWrap Mini if it won’t be used 
for a while, to help keep dirt and debris out of the USB ports.