Texas Instruments INA209EVM - INA209EVM Evaluation Module INA209EVM INA209EVM 데이터 시트
제품 코드
INA209EVM
www.ti.com
INA209EVM Hardware Setup
3.5
Connecting the USB Cable to the INA209EVM
shows the typical response to connecting the USB Dig platform to a PC USB port for the first
time. Note that the EVM must be powered prior to connecting the USB cable. Typically, the computer will
respond with a Found New Hardware, USB Device pop-up. The pop-up typically changes to Found New
Hardware, USB Human Interface Device. This pop-up indicates that the device is ready to be used. The
USB Dig platform uses the Human Interface Device Drivers that are part of the Microsoft Windows
operating system.
respond with a Found New Hardware, USB Device pop-up. The pop-up typically changes to Found New
Hardware, USB Human Interface Device. This pop-up indicates that the device is ready to be used. The
USB Dig platform uses the Human Interface Device Drivers that are part of the Microsoft Windows
operating system.
In some cases, the Windows Add Hardware Wizard will pop-up. If this prompt occurs, allow the system
device manager to install the Human Interface Drivers by clicking Yes when requested to install drivers.
device manager to install the Human Interface Drivers by clicking Yes when requested to install drivers.
Figure 9. Connecting the USB Cable
13
SBOU055A – February 2008 – Revised February 2010
INA209 Evaluation Module
Copyright © 2008–2010, Texas Instruments Incorporated