Telular Phonecell SX3i Amps Fixed Wireless Terminal SX3i 사용자 설명서

Installation Summary

HONECELL

SX3i AMPS

SER

ANUAL

12/08/99

Step 1. Choose an Antenna Location (pg. 6-7)

·· Choose a location.

·· Next, connect power to the FWT.

·· Then, connect the antenna (not supplied).

·· Check the cellular signal strength and

move the antenna until you achieve the

best signal possible.

Step 2. Plug In Your Phone (page 8)

·· Once the antenna is connected, hook up

a phone.

·· Then, make a test call to check noise levels,

and adjust the antenna location accordingly.

·· NOTE: If your Phonecell SX3i is not pre-pro-

grammed for NAM (Number Assignment Module)

information, youll need to perform the

NAM/Phone Number Setup in Step 3. Then, return

to this step (2).

·· Plug in additional phones, Fax and/or Modem.

Step 3. NAM/Phone Number Setup (pg. 9-11)

·· If your Phonecell was not pre-programmed for

NAM information, you need to perform the

NAM/Phone Number Setup procedure.

·· Otherwise, continue to Step 4.

Step 4. Battery Installation (pg. 12-13)

·· Follow these instructions to install optional bat-

teries (not included) for backup in the

event of AC power failure.

·· Otherwise, continue to Step 5.

Step 5. Wall or Desk Installation (pg. 14-15)

·· After youve selected a location and made all

the necessary connections and adjustments,

your Phonecell SX3i is ready for either

wall-mounting or desktop/tabletop use.

There are five steps to installing the Phonecell SX3i FWT properly.

These steps are summarized below and explained in detail in the

remainder of this manual.