BMW 2015 Z4 sDrive35is 사용자 매뉴얼

The screw-in tow fitting should always be car‐
ried in the vehicle. It can be screwed in at the
front or rear of the BMW.
It is stored in the onboard vehicle tool kit under
the cargo floor panel, refer to page 

.

Tow fitting, information on use

▷

Use only the tow fitting provided with
the vehicle and screw it all the way in.

▷

Use the tow fitting for towing on paved
roads only.

▷

Avoid lateral loading of the tow fitting, e.g.,
do not lift the vehicle by the tow fitting.

Otherwise, damage to the tow fitting and the
vehicle can occur.◀

Release the cover panel in the bumper:
Press on the recess at the bottom left in the
cover panel.

Release the cover panel in the bumper:
Press on the recess at the bottom center in the
cover panel.

Do not tow-start the vehicle.
Due to the Sport automatic transmission, the
engine cannot be started by tow-starting.
Have the cause of the starting difficulties rem‐
edied.

If possible, do not tow-start the vehicle but
start the engine by jump-starting, refer to
page 

, it. If the vehicle is equipped with a

catalytic converter, only tow-start while the en‐
gine is cold.

1.

Switch on the hazard warning system; .

2.

Switch on the ignition, refer to page 

3.

Shift into 3rd gear.

4.

Have the vehicle tow-started with the
clutch pressed and slowly release the
clutch. After the engine starts, immediately
depress the clutch completely again.

5.

Stop at a suitable location, remove the tow
bar or rope, and switch off the hazard
warning system.

6.

Have the vehicle checked.

Seite 256

256

Online Edition for Part no. 01 40 2 954 104 - II/15