HP NetServer NetRAID-4M 사용자 설명서

HP NetRAID-4M Cluster Services Installation Guide

Cluster Software Components and Quorum

7. Click Yes to the prompt to exit the setup.

8. Click Finish to close the Cluster Service Installation wizard.

9. Close the Add/Remove Programs and Control Panel windows.

CAUTION

For the NetRAID-4M/Server A installation, DO NOT continue past this point
using the standard Cluster Service Installation wizard.

10. Open a command prompt and type:

C:\winnt\cluster\cluscfg –localquorum <Enter>

This will restart the Cluster Service Configuration wizard in a “local quorum” installation
mode.

11. Click Next at the Cluster Service Configuration wizard screen.

12. Select the I understand … option and click Next.

13. Select the option The first node in the cluster, click Next.

14. Enter a name for the cluster.

(Example: Cluster1.) Click Next.

15. Enter the cluster service username and password.

(Example: MSCS/password) Click Next.

16. At the Configure Cluster Networks screen click Next.

17. In the Network Connection screen (shown below) enter the intra-cluster (heartbeat) LAN

name, (e.g.: Heartbeat), and it’s IP address, (e.g.: 10.1.1.1).

18. Select the Enable this network for cluster use option, then select Internal cluster

communications only and then click Next.