Watlow Electric Gateway & DeviceNet 사용자 설명서

 

                        

RUI/Gateway & DeviceNet

TM

  

 

      Configuration & Ladder Logic Example  

 

 Using an Allen-Bradley CompactLogix PLC 

Watlow  
1241 Bundy Blvd 
Winona, MN 55987 
Telephone: 507-494-5656 
© 2007 Watlow Electric Mfg Co                                1 

4/08 

 

 
1. 

Prior to making the physical connections on the network setup the gateway DeviceNet

TM

  

 

communications parameters per your network requirements, i.e., baud rate and node  

 

address. If your not sure how to do this go to

 http://www.watlow.com

 and download the EZ- 

ZONE

PM Communications Manual and follow the procedure defined in the DeviceNet

TM

 

chapter.   

 

2. 

Once the gateway communications parameters for DeviceNet

TM

 are set according to your 

network requirements connect the gateway into the network and do the following: 

 

 

a. Run RSLinx software and configure the driver of choice 

 

 

b. Run RSNetWorx software.  

 

3. 

As shown below (within RSNetWorx software), click on the online command from the tools 
toolbar and then select the appropriate communications path to browse the DeviceNet

TM

 

network. Set up in previous step using RSLinx software. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 
4. 

After successfully browsing the network all nodes on the network will appear in the graphical