BENDIX SD-03-821 사용자 설명서
3
FIGURE 3
TC-6
™
VALVE
DOUBLE CHECK VALVE
SERVICE LINE
REAR BRAKE
RESERVOIR
SUPPLY RESERVOIR
FRONT BRAKE
RESERVOIR
DOUBLE
CHECK
VALVE
TO REAR BRAKES
TP-3
™
VALVE
Position the torsion spring (8) in its approximate position in
the body so that the end which engages the handle rests
against the side of the body opposite the bracket retaining
screw holes. Place the roller cam (11) in position as shown
in Fig. 2 and insert pivot pin (13) through the torsion spring
and partially through the roller cam, leaving room to insert
the wedge shaped end of the handle.
the body so that the end which engages the handle rests
against the side of the body opposite the bracket retaining
screw holes. Place the roller cam (11) in position as shown
in Fig. 2 and insert pivot pin (13) through the torsion spring
and partially through the roller cam, leaving room to insert
the wedge shaped end of the handle.
With a small screwdriver or similar tool, force the tang of the
torsion spring towards the opposite wall of the body far
enough so the handle (10) may be inserted into the roller
cam. The pivot pin (13) may then be tapped on through
until the ends of the pin are flush with either side of the
body.
torsion spring towards the opposite wall of the body far
enough so the handle (10) may be inserted into the roller
cam. The pivot pin (13) may then be tapped on through
until the ends of the pin are flush with either side of the
body.
Place the mounting bracket in position and secure with two
slotted head cap screws (14).
slotted head cap screws (14).
Place the rubber knob back on the handle. Reinstall the
valve on the vehicle and test per “operating leakage checks”
in this manual.
valve on the vehicle and test per “operating leakage checks”
in this manual.
WARNING! PLEASE READ AND FOLLOW
THESE INSTRUCTIONS TO
THESE INSTRUCTIONS TO
AVOID
PERSONAL INJURY OR DEATH:
When working on or around a vehicle, the following
general precautions should be observed at all times.
general precautions should be observed at all times.
1.
Park the vehicle on a level surface, apply the
parking brakes, and always block the wheels.
Always wear safety glasses.
parking brakes, and always block the wheels.
Always wear safety glasses.
2.
Stop the engine and remove ignition key when
working under or around the vehicle. When
working in the engine compartment, the engine
should be shut off and the ignition key should be
removed. Where circumstances require that the
engine be in operation, EXTREME CAUTION should
be used to prevent personal injury resulting from
contact with moving, rotating, leaking, heated or
electrically charged components.
working under or around the vehicle. When
working in the engine compartment, the engine
should be shut off and the ignition key should be
removed. Where circumstances require that the
engine be in operation, EXTREME CAUTION should
be used to prevent personal injury resulting from
contact with moving, rotating, leaking, heated or
electrically charged components.
3.
Do not attempt to install, remove, disassemble or
assemble a component until you have read and
thoroughly understand the recommended
procedures. Use only the proper tools and observe
all precautions pertaining to use of those tools.
assemble a component until you have read and
thoroughly understand the recommended
procedures. Use only the proper tools and observe
all precautions pertaining to use of those tools.
TO FRONT
BRAKES