Elite AP-3000 사용자 설명서

ongratulations on your purchase of the AP-3000 Avionics 

C

Panel. This guide is an addendum to the ELITE Hardware 

Installation Manual and will provide the necessary information 
for proper setup of the AP-3000. 

IMPORTANT
The AP-3000 comes with its own special Power Supply. Using a 
different power supply will cause unpredictable results and may 
damage the AP-3000.   

!

The AP-3000 Power Supply should only be used to power 
the AP-3000 by itself. Do NOT use AP-3000 Power Supply 
to power other components.

!

Connect AP-3000 as shown in the diagrams on the opposite 
page or in the ELITE  Hardware Installation Manual.

!

Refer to the ELITE Hardware Installation Manual for 
information on connecting other system components as 
applicable.

NOTE:
The AP-3000 is designed to be similar in operation and function 
to common avionics stacks found in actual aircraft. With few 
exceptions, its use should be intuitive and integrate easily with 
any system. A few functions unique to the AP-3000 are the 
AUX 1 & AUX 2 toggle switches (pictured below). AUX 1 is an 
ON/OFF style switch that controls the display of the on-screen 
Moving Map. AUX 2 is used for DME selection in the King Air.

AUX 1 & 2 toggle switches

(back view)

Rudder

Avionics

UCI

flight console

(

25 pin - 9 pin cable

  

 

)

Power

(back view)

Avionics

(

9 pin -  9 pin cable

)

  

(back view)

(back view)

Extended

Standard

Avionics

(

9 pin -  9 pin cable

)

  

quadrant

(

25 pin - 25 pin cable

  

 

)

External power   connections 
not shown.

 

IOIOIO

IOIOIO