Insignia 08-1623 사용자 설명서
5
Insignia NS-C3113 Car CD Deck
www.insignia-products.com
Installing your car CD deck
Installation method 1 - DIN front mount
To install the car CD deck using the DIN front
mount:
mount:
1 Slide the mounting sleeve into the opening
you have prepared in the dashboard.
2 When the mounting sleeve is in the correct
position, bend several mounting
claws
outward to achieve a tight fit and lock the
mounting sleeve into place.
mounting sleeve into place.
3 Install the outer trim frame on the CD deck.
4 Connect the antenna, the main wire harness
(see “Wiring your car CD deck” on page 6),
and the rear mounting bolt (if necessary to
support your CD deck).
and the rear mounting bolt (if necessary to
support your CD deck).
9
AUX
In port
Plug an external audio source into the 3.5 mm port.
10
AMS button
In radio mode, press briefly to scan each stored station for five seconds. Press and
hold to store station presets (six for each radio band).
In MP3 mode, press to enter search modes.
hold to store station presets (six for each radio band).
In MP3 mode, press to enter search modes.
11
BAND button
Press to switch radio bands between FM1 - FM2 - FM3 - AM1 - AM2.
12
Preset buttons (radio)
Playback controls (CD)
Playback controls (CD)
In radio mode, press to access station presets in each band.
In CD playback mode, press the following:
In CD playback mode, press the following:
• 1/
(play/pause)
• 2/INT (intermittent)
• 3/RPT (repeat)
• 4/RDM (random)
• 5/DN (down)
• 6/UP (up)
• 3/RPT (repeat)
• 4/RDM (random)
• 5/DN (down)
• 6/UP (up)
13
MUTE button
Press to mute the sound. Press again to restore the sound.
14
VOL (volume) knob/
SEL button
SEL button
Turn clockwise to increase the volume. Turn counterclockwise to decrease the
volume.
Press to select the sound characteristic mode you want. Choices include VOL
(volume - default), BAS (bass), TRE (treble), FAD (fader), and BAL (balance). When
you select a characteristic, turn the VOL knob to adjust.
Press and hold for three seconds to cycle through DSP OFF, ESP 12, SEEK 1, and
BEEP ON.
volume.
Press to select the sound characteristic mode you want. Choices include VOL
(volume - default), BAS (bass), TRE (treble), FAD (fader), and BAL (balance). When
you select a characteristic, turn the VOL knob to adjust.
Press and hold for three seconds to cycle through DSP OFF, ESP 12, SEEK 1, and
BEEP ON.
• DSP OFF–Turn the VOL knob to cycle through the sound presets. Choices
include POP, ROCK, CLASS, FLAT, and DSP OFF.
• ESP 12–Turn the VOL knob to choose between ESP 12 and ESP 45. (Sets
the level of Electronic Shock Protection - use higher setting on rougher
roads)
roads)
• BEEP ON–Turn the VOL knob to choose between BEEP ON and BEEP OFF.
(When enabled, your radio sounds a beep when you press a knob)
• SEEK–Turn the VOL knob to choose between SEEK 1 and SEEK 2. (Sets the
way the radio seeks stations)
#
Description
Function
Opening size
7.16 in (182 mm) × 2.1 in (53 mm)
7.16 in (182 mm) × 2.1 in (53 mm)