M-S Cash Drawer A794 사용자 설명서
Chapter 6: Programming Information
A794 Owner’s Guide
December 1999
72
Horizontal Positioning Commands
The horizontal positioning commands control the horizontal print positions of
characters on the receipt.
characters on the receipt.
The commands describe operation for 80 mm paper. If the printer supports 82.5 mm
paper, the dot spacing is the same but there are 640 printable dots rather 576 printable
dots on the 80 mm paper.
paper, the dot spacing is the same but there are 640 printable dots rather 576 printable
dots on the 80 mm paper.
Horizontal Tab
ASCII
HT
Hexadecimal
09
Decimal
9
Moves the print position to the next tab position set by the Set Horizontal Tab Positions
(1B 44 n1 n2 ... 00) command. The print position is reset to column one after each line.
(1B 44 n1 n2 ... 00) command. The print position is reset to column one after each line.
Tab treats the left margin as column one, therefore changes to the left margin will move
the tab positions.
the tab positions.
When no tabs are defined to the right of the current position, or if the next tab is past the
right margin, Line Feed is executed. HT has no effect in Page Mode.
right margin, Line Feed is executed. HT has no effect in Page Mode.
Print initialization sets 32 tabs at column 9, 17, 25…
Set Column
ASCII
ESC DC4 n
Hexadecimal
1B 14 n
Decimal
27 20 n
Value of n:
1-44= Standard pitch
1-56= Compressed pitch
1-56= Compressed pitch
Default of n:
1
Prints the first character of the next print line in column n. It must be sent for each line
not printed at column one. The value of n is set to one after each line.
not printed at column one. The value of n is set to one after each line.
Exceptions
This command cannot be used with Single- or Double-Density graphics.
Related Information
This is ignored in TM-T88 Emulation and the parameter byte goes into the print buffer.