Westinghouse 22 Watt (replaces 32 Watt) T8 Linear LED Light Bulb 0365500 지침 매뉴얼
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF
are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting.
All rights reserved.
Made in China
INSTALLATION GUIDE
Please read all information before installing the lamps and keep this sheet for future reference.
• These lamps are direct replacements for 32W T8 lamps only.
• Also dimmable when used with applicable ballast
• Operates on Instant Start Electronic Ballast only.
• Risk of Fire: Do not install this lamp in a preheat luminaire.
• Risk of electronic shock - Use only in dry locations.
• Any modifications to this product will void the warranty.
• This lamp may not be compatible with all ballasts, go to www.westinghouselighting.com for compatibility information.
IMPORTANT SAFETY INFORMATION:
CAUTION: If the lamp or luminaire exibits undesireable operation (buzzing, flickering etc.), immediately turn off power, remove lamp from
luminaire and contact us at www.westinghouselighting.com.
Risk of fire. Do not install in a pre-heat luminaire.
This lamp only operates on electronic ballasts. If lamp does not light when the luminaire is energized, remove lamp from luminaire and contact us at
www.westinghouselighting.com or qualified electrician.
This device is not intended for use with emergency exit fixtures or emergency exit lights.
Lamps must be operated within an ambient fixture temperature of -22
o
F and 133
o
F to ensure ul compliance.
INSTALLATION INSTRUCTIONS
Turn off the power to the
luminaire before removing
the lamp.
STEP 1.
STEP 2.
STEP 3A.
STEP 3B.
STEP 4A.
STEP 4B.
STEP 5.
STEP 6.
Remove the diffuser, lens
cover or louver (if provided).
Fluorescent lamps to be
Fluorescent lamps to be
replaced with Westinghouse
LED T8 lamps are shown
above.
Remove the fluorescent lamp.
First, rotate the lamp 90’
degrees.
Then, remove the lamp from
the lampholder.
Insert the Westinghouse
LED replacement lamp.
Then, rotate the lamp 90’
degrees.
Make sure that the pins are
Make sure that the pins are
completely seated in the
lampholders. One LED
lamp for each fluorescent
lamp removed.
Repeat steps 3 and 4 as
needed for additional lamps.
Replace the diffuser, lens
cover or louver (if removed in
step 2).
Turn the power to the
luminaire back on.