Bulldog Security 1402 사용자 설명서

‘                                                                                  ‘

‘

‘

You must use optional part #775.

Select a location under the hood for the siren. For best results, the location

should meet the following conditions:

•The mounting location should be solid and have no moving parts nearby.

•For the loudest sound, the siren should point down.

•The siren should not point straight up as moisture could collect in the

siren horn and damage the system.

•To prevent water damage, the siren should NOT be mounted in a wheel

well, directly behind the radiator grill or close to the ground.

•Mount the siren as far away from sources of heat, i.e. exhaust manifold,

turbo charger, etc. as possible. Tape, wrap or tube all wires. Run all

wires to the siren as high up in the engine compartment as possible to

prevent cutting from below.

15

LOCATING & MAKING

CONNECTIONS 

CONT.

86

85

87

30

87a

Using the siren base as a template, mark the three mounting holes.

Drill a 1/8 inch hole at each mounting hole location, taking care not to

damage anything behind the mounting surface.

Secure the siren to the mounting location with two of the mounting

screws.

Connect the wires as shown.

16

LOCATING & MAKING

CONNECTIONS 

CONT.

BLUE PLUG

LED

INDICATOR

GROUND

OVER-

RIDE

SWITCH

WHITE

PLUG

22 GA BLACK WIRE WITH GREEN TAG

(Shock or microwave sensor - negative

input), optional accessories required

Select a location for the

override switch. You

should be able to reach

the switch when sitting

in the driver’s seat, but

the switch should be

hard to find. A typical mounting location is under the dash. The

mounting surface should be less than 1/8 inch thick.