Benq PE7700 사용자 설명서

  19

  Using the projector and remote control

Eng
lish

Using the projector and remote control

Preparations

Turning the power on

Follow the steps below.

1.

Make sure the Power light is orange after power has been applied and the 
main AC power switch is turned on. 

2.

Press and hold the POWER button on the projector or remote control to 
turn the projector on.

3.

The fans will be running. A start-up image shows on the screen for a few 
seconds. 

4.

" Searching…." will be displayed on the screen before the projector 
identifies the input signal. This message will remain on the screen until a valid signal is detected.

5.

If the horizontal frequency of the input signal exceeds the range of the projector, a message reading " 
Unsupported timing" will be displayed on-screen. This message will remain on-screen until you change 
the input signal.

Switching input signals

The projector can be connected to multiple equipment at the same time. To 
sequentially select input signals, press one of the Source buttons on the remote 
control or SOURCE/ENTER on the projector.

Q

When the projector is turned on, it will search for the input source you 
last selected.

Q

If you need to use the PIP or POP function, refer to page 

 for advanced 

operation.

1.

Turn all of the connected equipment on.

2.

Remove the lens cap. 

3.

Plug the supplied power cable into the AC inlet on the 
rear of the projector and turn the main AC power 
switch on. 

4.

Plug the power cable into a wall socket and turn the 
wall switch on.