Giant Plumbing Product Triplex Ceramic Plunger Pump 사용자 설명서

P217A-3100/5100 HORSEPOWER

REQUIREMENTS

RPM GPM 800 PSI 1200 PSI 1500 PSI 1700 PSI 2000 PSI
1725

1.7

0.9

1.4

1.7

2.0

2.3

3000

3.0

1.7

2.5

3.1

3.5

4.1

3200

3.2

1.8

2.6

3.3

3.8

4.4

3450

3.4

1.9

2.8

3.5

4.0

4.7

Specifications

Model P217A-3100/5100

NOTE:

In order to drive the pump from the side opposite the present
shaft extension, simply remove the valve casing from the crank-
case and rotate the pumps 180 degrees to the desired position.
Be certain to rotate the seal case (item #20) as well, so that the
weep holes are down at the six o'clock position. Exchange the oil
fill and the oil drain plugs, also. Refer to the repair instructions as
necessary for the proper assembly sequence.

HORSEPOWER RATINGS:
The rating shown are the power
requirements for the pump. Gas
engine power outputs must be
approximately twice the pump
power requirements shown above.

We recommend a 1.15 service
factor

be specified when

selecting an electric motor as the
power source.

To compute

specific pump horse power require-
ments, use the

follow-

ing formula:

HP = (GPM X PSI) / 1450

Consult the factory for special requirements that must be met if the pump is
to operate beyond one or more of the limits specified above.

SPECIAL NOTE:

The theoretical gallons per revolution

(gal/rev) is 0.0009855.

To find specific outputs at various RPM,

use the formula: GPM = 0.0009855 x RPM

Volume ................................................................................................... Up to 3.4 GPM
Discharge Pressure ................................................................................ Up to 2000 PSI
Inlet Pressure ......................................................................................... Up to 90 PSI
RPM ...................................................................................................... Up to 3450 RPM
Plunger Diameter .................................................................................... 18mm
Stroke ..................................................................................................... 5.5mm
Temperature of Pumped Fluids ............................................................... Up to 160

Inlet Ports ............................................................................................... (2) 3/8" BSP
Discharge Ports ...................................................................................... (2) 3/8" BSP
Shaft Rotation ............................................................................. Top of Pulley Towards Fluid End
Crankshaft Diameter .............................................................................. 24mm
Key Width .............................................................................................. 8mm
Shaft Mounting ....................................................................................... Right Side Facing Manifold
Weight .................................................................................................... 11 lbs. 11oz.
Crankcase Oil Capacity .......................................................................... 6.5 fl.oz.
Volumetric Efficiency @ 1750 RPM ....................................................... 0.90
Mechanical Efficiency @ 1750 RPM ...................................................... 0.88