Brother MFC-J4710DW 빠른 설정 가이드
3
e
Gently put the paper into the paper tray (for
MFC-J4710DW, tray #1) print side down and
top edge first.
MFC-J4710DW, tray #1) print side down and
top edge first.
f
Gently adjust the paper guides to fit the paper.
Make sure that the paper guides touch the
edges of the paper.
Make sure that the paper guides touch the
edges of the paper.
g
Check that the paper is flat in the tray and
below the maximum paper mark a. Close the
output paper tray cover.
below the maximum paper mark a. Close the
output paper tray cover.
h
Slowly push the paper tray completely into the
machine.
machine.
i
While holding the paper tray in place, pull out
the paper support a until it clicks, and then
unfold the paper support flap b.
the paper support a until it clicks, and then
unfold the paper support flap b.
IMPORTANT
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
far; it may lift at the back of the tray and cause
paper feed problems.
1
NOTE
• For printing and copying on special media,
open the manual feed slot a on the back of the
machine. Feed only one sheet at a time of
Ledger, Legal, A3, envelopes, or thicker paper
when using the manual feed slot.
For details, see Loading paper in the manual
feed slot in chapter 2 of the Basic User’s
Guide.
machine. Feed only one sheet at a time of
Ledger, Legal, A3, envelopes, or thicker paper
when using the manual feed slot.
For details, see Loading paper in the manual
feed slot in chapter 2 of the Basic User’s
Guide.
• (MFC-J4710DW)
For information about tray #2 (the lower tray),
see Loading paper in paper tray #2 in chapter
2 of the Basic User’s Guide.
see Loading paper in paper tray #2 in chapter
2 of the Basic User’s Guide.
2
1
1