Benq AWL-100 사용자 설명서
BENQ Corporation
15
Chapter 4. Trouble Shooting
Question 1
What should the users do when the signal icon Cable Disconnected appeared
right after pressing the ReScan or Disable Radio button under Peer-to-Peer
(Ad-hoc) mode?
Answer 1
Please remove the BenQ AWL100 PC Card from the PCMCIA slot and re-insert the
device again, and then it will connect the user back on line.
Question 2
What if the user’s PC is unable to connect to the other PC right after switching the
network type from access point mode to Peer-to-Peer mode?
Answer 2
Please make sure the SSID for both PC are the same and the IP address are in the
same subnet. If both SSID and IP address are checked and the same, but the PC is
still in disconnection mode, then please remove the BenQ AWL100 PC Card from
the PCMCIA slot and re-insert the device again to connect back online.
What if the user’s PC is unable to connect to the other PC right after switching the
network type from access point mode to Peer-to-Peer mode?
Answer 2
Please make sure the SSID for both PC are the same and the IP address are in the
same subnet. If both SSID and IP address are checked and the same, but the PC is
still in disconnection mode, then please remove the BenQ AWL100 PC Card from
the PCMCIA slot and re-insert the device again to connect back online.
Question 3
What if the users lost connection due to distance, but still unable to connect to each
other after move both devices closer under Peer-to-Peer (Ad-hoc) mode?
Answer 3
Please remove the BenQ AWL100 PC Card from the PCMCIA slot and re-insert the
device again, and then it will connect the devices back on line.
Question 4
What if the user is unable to alliance with the new association after moving from
one AP service set to another under the Access Point (Infrastructure) mode?
Answer 4
Please ensure that the SSID is the same for both APs and PC. If the SSID is correct,
then please press the ReScan button in the Status menu, and then it should create
new association for the device with the AP.
What if the users lost connection due to distance, but still unable to connect to each
other after move both devices closer under Peer-to-Peer (Ad-hoc) mode?
Answer 3
Please remove the BenQ AWL100 PC Card from the PCMCIA slot and re-insert the
device again, and then it will connect the devices back on line.
Question 4
What if the user is unable to alliance with the new association after moving from
one AP service set to another under the Access Point (Infrastructure) mode?
Answer 4
Please ensure that the SSID is the same for both APs and PC. If the SSID is correct,
then please press the ReScan button in the Status menu, and then it should create
new association for the device with the AP.