Behringer Eurolight LC2412 사용자 설명서
21
EUROLIGHT LC2412 User Manual
9.3.2 Sub D connections (Analog Control)
The following table shows the cable layout of the individual contacts of the sub D
The following table shows the cable layout of the individual contacts of the sub D
connection for analog dimmer control.
Pin No.
Cons. channel
Pin 1
Channel 1
Pin 2
Channel 2
Pin 3
Channel 3
Pin 4
Channel 4
Pin 5
Channel 5
Pin 6
Channel 6
Pin 7
Channel 7
Pin 8
Channel 8
Pin 9
Channel 9
Pin 10
Channel 10
Pin 11
Channel 11
Pin 12
Channel 12
Pin 13
Special 1
Pin 14
Special 2
Pin 15
Ground
Table. 9.1: Cable layout of the sub D connection
9.3.3 MIDI connection
Coonect to other MIDI equipment or another EUROLIGHT LC2412 by using
Coonect to other MIDI equipment or another EUROLIGHT LC2412 by using
common MIDI cables. The cables should never be longer than 15 m (45 ft).
9.3.4 Audio connections
To control the EUROLIGHT LC2412 via an audio signal, please use a mono jack
To control the EUROLIGHT LC2412 via an audio signal, please use a mono jack
connector with standard configuration.
strain relief clamp
sleeve
tip
sleeve
(ground/shield)
Unbalanced ¼" TS connector
tip
(signal)
Fig. 9.2: 1/4" TS connector for audio signals
9.3.5 Footswitch
You can use a footswitch to trigger chase steps. This way, both of your hands
You can use a footswitch to trigger chase steps. This way, both of your hands
remain free, letting you control additional settings of your LC2412.
strain relief clamp
sleeve
sleeve
tip
sleeve
pole 1/ground
tip
pole 2
The footswitch connects both poles momentarily
¼" TS footswitch connector
Fig. 9.3: Footswitch connector
As long as a footswitch is kept pressed, the connection of both contacts is closed.
Therefore, a footswitch does not act as a switch.
9.4 Rack mounting
Your EUROLIGHT LC2412 is factory-equipped with rack-mounting brackets.
You can screw these on to the side of your LC2412 on a per-need basis.
◊
Always make sure that your LC2412 is provided with sufficient
ventilation to avoid overheating of the unit!
ventilation to avoid overheating of the unit!