Brother MFC-3340CN 빠른 설정 가이드
4
Setting Up the Machine
1
Remove the protective tape and paper.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.
Connecting the USB cable is done
when installing the driver.
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
machine and remove the output paper tray.
2
Press and slide the paper guide to fit the
paper width.
paper width.
3
Pull out the paper support and unfold the
paper support flap.
paper support flap.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
jams and mis-feeds.
5
Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
below the maximum paper mark.
print side down and top edge first.
Check that the paper is flat in the tray and
below the maximum paper mark.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
the paper tray firmly back into the machine.
1
Removing the Protective
Parts
Parts
2
Loading Paper
You can load up to 100 sheets of 20 lb
paper.
For more details, see “About paper” in
Chapter 1 of the User’s Guide.
paper.
For more details, see “About paper” in
Chapter 1 of the User’s Guide.
Paper Side Guide
Use the paper support flap for Letter, Legal
and A4 size paper.
and A4 size paper.
■ Make sure the paper side guides touch
the sides of the paper.
■ Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
and cause paper feed problems.
Paper Support Flap
Paper Support
Step 1