Bradford-White Corp THROUGH-THE-WALL GAS WATER HEATER 사용자 설명서

 

 

4

 

 
This gas-fired water heater’s design is certified by CSA International under the 
American National Standard Z21.10.1 - (as indicated on the rating plate) and 
CSA 4.1-M - (as indicated on the rating plate). 
 
This water heater must be installed in accordance with local codes or, in the 
absence of local codes, the National Fuel Gas Code, ANSI Z223.1-Latest 
Edition) and/or in Canada CAN/CGA B149 Installation Codes (Latest Editions).  
The warranty for this water heater is in effect only when the water heater is 
installed, adjusted, and operated in accordance with these Installation and 
Operating Instructions. The manufacturer will not be held liable for any damage 
resulting from alteration and/or failure to comply with these instructions. 
 
This water heater is not design certified for installation in a mobile home. Such an 
installation may create a hazardous condition and will nullify the warranty. 
 

 
Do not use this appliance if any part has been submerged in water. You should 
contact a qualified service technician to inspect the appliance and to replace any 
part of the control system including the combination gas control which has been 
submerged in water. 

 

Make sure that you check the rating plate and combination gas control on the 
water heater to be certain that the type of gas being supplied corresponds with 
the marking on the rating plate and combination gas control.

 

 

Before proceeding, please inspect the water heater and its components for 
possible damage.  DO NOT install any damaged components.  If damage is 
evident then please contact the supplier where the water heater was purchased 
or the manufacturer listed on the rating plate for replacement parts.