Bosch 2400ES 사용자 설명서

6

6 720 606 990

Electrical strip connectors

B At the ignition electrodes, pull off the

2 yellow igniter wires that come from
the top of the control unit (Fig.  2,
pos. 3). Then pull the complete
control unit forward and out of the
heater, pull up the power supply
cord further if more slack is needed.

B While holding the unit in one hand or

resting it on a flat surface, remove
the front cover of the control unit by
removing the 4 screws.

B Open control unit top cover (Fig. 3,

pos. 1).

B Remove the protective paper (Fig. 3, 

pos. 2) from one face of the support 

and attach it to the main PCB as 
shown in Fig. 4.

B Remove the other protective paper

and attach the remote control PCB
as shown in Fig. 5.

Once auxiliary 
cover is off, pull 
off the two 
electrical strip 
connectors from 
the board. Once 
off, the wiring 
harness can be 
removed from the 
case by pulling 
their rubber seals 
outward.

6720606990-0701_(Remote control)16Nov.fm  Page 6  Friday, November 16, 2007  3:04 PM