Bracketron Multi Vehicle Mount MVM-35-05 사용자 설명서

MVM Instructions | 

IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers 

seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic 

parts of a vehicles dash. 

Unnecessary force or pressure can cause pieces to crack or break.

PARTS INCLUDED: MVM-35-05 Mount, 3 - #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel and Hardware.

TOOLS NEEDED FOR MVM MODIFICATION (if required)

4 inch Mounted Bench Vise 

12 oz. Ball Pein Hammer 

Standard Tin Snips

Small File 

Dash Trim Tool (Part #SIT-104)

# 2 Phillips Screwdriver

9/32” Open End Wrench (for swivel)

Marking Pen

Begin installation by removing the long trim on the right side of the 

radio/ center console. Insert a Dash Trim tool (part #SIT-104) in the 

location as shown in the picture to the left. Work your way along this trim 

releasing all the clips. Note: Some of the clips are tight. Use caution. Set 

the trim aside in a safe place.

Ship to Step 5 on the following page if you have not yet formed the 

bracket to fit your vehicle. 

Remove the one (1) Phillips screw on the right side of the radio, just below 

the knob on the right side. Set the screw aside in a safe place. Place the 

MVM over the hole and replace the factory screw.

Carefully reinstall the dash in reverse order securing all screws and clips 

to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi 

Vehicle Mount or any other AMPs compatible device.

Your installation is complete

    Install 

Mount Here

  

Note:

 The hole pattern on the face of the MVM maybe 

different then what is shown in the pictures.