Weber PLATINUM 3400 Series Natural Gas Barbecue 사용자 설명서

Install manifold bracket

You will need: manifold bracket

Hook the bracket onto the manifold at the center burner
valve. Figure 17. Place your hand underneath the bracket.
Lift the bracket, manifold and cooking box slightly as a unit
and hook onto the frame brace.

Frame brace

Manifold bracket

Install brace panel 

You will need: brace panel.

Slide the side burner back. Insert the tabs into the slots in
the frame brace at the wheel legs. (Make sure the side
burner hose is to the front of the barbecue.) Figure 18 (a).
Slide up until the notch at the bottom of the brace panel fits
over the cross brace. Figure 18 (b).

Slot in frame brace

Frame brace

Tabs on 
brace panel

Cross brace

Side burner
hose

Side burner hose

Install right end panel

You will need: right end panel (Number 3), 1/4-20 x 
1 1/2 inch bolt, 1/4-20 hex nut, two nylon washers, 
1/4-20 x 1/2 inch bolt, 1/4-20 wing nut and a 7/16 inch
wrench.

Set the right end panel over the brace panel. Make sure
the gas supply hose is on the outside of the panel. Put the
washer on the 1/4-20 x 1 1/2 inch bolt and insert bolt
through both panels and frame brace. Add hex nut and
tighten. Figure 19.

Place a nylon washer on the 1/4-20 x 1/2 inch bolt. Insert
the bolt through the top of the right end panel and the
brace panel. Put on wing nut and tighten. Figure 20.