Weber Genesis Silver A 사용자 매뉴얼
B-4
(1)
(2)
Install Gas Supply
General Specifications for Piping
Note - Contact your local municipality for building
codes regulating outdoor gas barbecue
installations. In absence of Local Codes, you must
confirm to the latest edition of ANSI Z223.1. WE
RECOMMEND THAT THIS INSTALLATION BE DONE
BY A PROFESSIONAL.
Some of the following are general requirements taken
from ANISI Z223.1 latest edition for complete
specifications.
General Specifications for Piping
Note - Contact your local municipality for building
codes regulating outdoor gas barbecue
installations. In absence of Local Codes, you must
confirm to the latest edition of ANSI Z223.1. WE
RECOMMEND THAT THIS INSTALLATION BE DONE
BY A PROFESSIONAL.
Some of the following are general requirements taken
from ANISI Z223.1 latest edition for complete
specifications.
■
This barbecue is designed to operate at 7 inches of
water column pressure (.2526 psi).
■
A manual shut-off valve must be installed outdoors,
immediately ahead of the quick disconnect.
■
An additional manual shut-off valve indoors should
be installed in the branch fuel line in an accessible
location near the supply line
location near the supply line
■
The quick disconnect connects to a 3/8 inch NPT
thread from the gas source. The quick disconnect
fitting is a hand-operated device that automatically
shuts OFF the flow of gas from the source when the
barbecue is disconnected
fitting is a hand-operated device that automatically
shuts OFF the flow of gas from the source when the
barbecue is disconnected
■
The quick disconnect fitting can be installed
horizontally, or pointing downward. Installing the fitting
with the open end pointing upward can result in
collecting water and debris.
with the open end pointing upward can result in
collecting water and debris.
■
The dust covers (supplied plastic plugs) help keep
the open ends of the quick disconnect fitting clean
while disconnected.
while disconnected.
■
Pipe compound should be used which is resistant to
the action of natural gas when connections are made.
■
The outdoor connector must be firmly attached to
rigid, permanent construction.
WARNING: Do not route the 12 foot hose under
a deck. The hose must be visible.
Install frame connector
You will need: frame connector, two 1 3/4 inch bolts,
two nylon washers and a 7/16 inch or adjustable
wrench.
Add nylon washer to the bolt, insert bolt through the
hole in the bottom center of the wheel frame and into
the end of the frame connector(1). Insert the other bolt
with a washer on it through the leg frame and into the
other end of the frame connector. Hold the frame
connector square and tighten the bolts with the
wrench.
You will need: frame connector, two 1 3/4 inch bolts,
two nylon washers and a 7/16 inch or adjustable
wrench.
Add nylon washer to the bolt, insert bolt through the
hole in the bottom center of the wheel frame and into
the end of the frame connector(1). Insert the other bolt
with a washer on it through the leg frame and into the
other end of the frame connector. Hold the frame
connector square and tighten the bolts with the
wrench.
(1)
Install manifold bracket
You will need: manifold bracket.
Hook the bracket(2) onto the manifold in the center.
Place your hand underneath the bracket. Lift the
manifold, bracket and cooking box slightly, then hook
the tab of the bracket onto the frame brace(1).
You will need: manifold bracket.
Hook the bracket(2) onto the manifold in the center.
Place your hand underneath the bracket. Lift the
manifold, bracket and cooking box slightly, then hook
the tab of the bracket onto the frame brace(1).